Y pipe for CL175 headers?

[silverheli2000]

Hi All,

Does anyone know where I can go (or where to purchase) a Y pipe for my CL175 headers? I have sourced a decent set of headers that I'm fitting on my CB175. There is no muffler and my goal would be to trim these headers up a bit and flush them up, install a Y (1.5" ID on the 2 inlets, 1.75" OD on the outlet) and then ultimately have a single muffler mounted out the back.

Any ideas?

I appreciate any help. I'm over in New Palestine.

Thanks!!

[gr1976]

if you are cutting the headers, there probably isn't a pre-made y-pipe to your exact dimensions...just my guess, especially for a 175

however, you can fab up about anything and a good start might be here:

www.mandrel-bends.com

[silverheli2000]

I finished up my system recently and figured I'd post a couple pictures up here to show the final product.

I ended up ordering 2 45 degree 1.5" elbows from Jegs (5.99 a piece), and scored a 8 inch piece of 1.75" pipe from the local shop here for free. Throw in a hacksaw, welder, bench grinder, high temp paint, reverse megaphone shorty muffler from ebay, and some exhaust wrap and I've got the system of my dreams!

Let me know what you think!

Attachments:

[silverheli2000]

Here it is all welded up and wrapped. The prior picture was the raw pipes painted with high temp paint mocked up.

Attachments:

[taggat]

like the rear seats, who makes those?

[novafrk]

Looks like Honda made the seat... did auto correct change "sets" to seats?